P
APER
H
ANDLING
3.7
3
To load print media in the Bypass tray:
1
Lower the Bypass tray, located on the right side of the
product. Unfold the paper support extension as shown.
2
Prepare a stack of paper or envelope for loading by flexing
or fanning them back and forth. Straighten the edges on a
level surface.
For transparencies; hold the transparencies by the edges
and avoid touching the print side. Oils from your fingers
that are deposited on the transparency can cause print
quality problems. If you are using the transparencies with
paper backing, insert a sheet of plaing paper on the tray
before loading transparencies. Doing so prevents paper
jams while feeding.
3
Load the print material with the print side facing down and
against the right edge of the tray.
Bypass tray
Paper support
To Next Page
Loading...
