Getting started_ 1
1.getting started
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
This chapter includes:
• Settin
g up the hardware
• Supplied software
• System requirements
• Installing USB connected machine’s driver
• Sharing your machine locally
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware, as is explained in the
Quick Install Guide. Make sure you read the Quick Install Guide first and
follow the steps below:
1. Select a stab
le location.
Select a level, stable place with adequate sp
ace for air circulation. Allow
extra space to open covers and trays.
The area should be well ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,500 m (4,921 ft). Refer to the
altitude
setting to optimize your printing. (See "Altitude adjustment" on
page 1.)
Place the machine on a flat, stable surface so th
at there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
2. U
npack the machine and check all the enclosed items.
3. R
emove tape holding the machine securely.
4. Install
the toner cartridge.
5. L
oad paper. (See "Loading paper in the tray" on page 3.)
6. Make sure that all cables are connected to the machine.
7. T
urn the machine on.
To Next Page
Loading...
