Copying_ 5
1. Place the front side of an original facing down on the scanner glass
where arrows indicate as shown, and close the scanner lid.
2. Press Copy from the main screen.
3. Select th
e tray in Paper Supply.
4. Pr
ess the Advanced tab > ID Copy.
5. Pr
ess Start on the control panel.
Then the machine starts scanning the front side.
6. Turn
the original over and place it on the scanner glass, where arrows
indicate as shown then, close the scanner lid.
7. Press Start on the control panel to begin copying.
•If the original is larger than the printable area, some portions may not
be printed.
•If this option is grayed out, select the Duplex option to 1 -> 1 Sided,
the Output option to Collated.
2-up or 4-up copying (N-up)
The machine reduces the size of the original images and prints 2 or 4 pages
onto one sheet of paper.
2 or 4-up copying is available only when you load originals into the
document feeder.
1. Place the originals face up in the document feeder. (See "Loading
originals" on page 1.)
2. Pr
ess Copy from the main screen.
3. Select th
e tray in Paper Supply.
4. Pr
ess the Advanced tab > N-Up.
5. Select Off, 2U
p, or 4Up.
•Off:
Copies an original onto one sheet of paper.
•2U
p: Copies two separate originals onto one page.
•4U
p: Copies four separate originals onto one page.
6. Pr
ess Start on the control panel.
You cannot adjust the copy size using the Reduce/Enlarge for the
N-Up feature.
Poster copying
Your original will be divided into 9 portions. You can paste the printed pages
together to make one poster-sized document.
This copy feature is available only when you place originals on the scanner
glass.
1. Place a single original face down on the scanner glass and close the
scanner lid. (See "Loading originals" on page 1.)
2. Pres
s Copy from the main screen.
3. Select the tray
in Paper Supply.
4. Pre
ss the Advanced tab > Poster Copy.
This feature is available only when the options in the Basic tab are
selected as below;
•Duplex to 1 -> 1 Sid
ed
•Reduce/Enlarge to Original (100%)
•Paper Supply to Tray
5. Pres
s On to activate this feature.
6. Pres
s OK.
7. Pres
s Start on the control panel to begin copying.
Your original is divided into 9 portions. Each portion is scanned
and printed one by one in the following order:
Clone copying
The machine prints multiple original images on a single page. The number
of images is automatically determined by the original image and the paper
size.
This copy feature is available only when you place originals on the scanner
glass.
1. Place a single original face down on the scanner glass and close the
scanner lid. (See "Loading originals" on page 1.)
2. Pres
s Copy from the main screen.
3. Select the tray
in Paper Supply.
4. Pre
ss the Advanced tab > Clone Copy.
This feature is available only when the options in the Basic tab are
selected as below;
•Duplex to 1 -> 1 Sid
ed
•Reduce/Enlarge to Original (100%)
•Paper Supply to Tray.
To Next Page
Loading...
