Samsung SCX-5935FN - Page 141

Alignment & Troubleshooting
Service Manual
4-90
Samsung Electronics
4.2.3.5(c) Abnormal Printing
4.2.3.5(d) SPOOL Error
Check and Cause Solution
1. Set up the parallel port in the CMOS SETUP.
2. Printer Driver Error.
3. Error message from insufcient memory.
(The printing job sometimes stops or due
to insufcient virtual memory, but it actually
comes from the insufcient space of the hard
disk.)
1. Select SPP(Normal) or ECP LPT Port the among ECP, EPP or SPP in
the CMOS Setup.
2. Check the printer in My Computer.(to see if the printer driver is
compatible to the present driver or delete the old driver, if defective and
reinstall the new driver)
3. Delete the unnecessary les to secure enough space of the hard disk
and start printing job again.
Check and Cause Solution
1. Insufcient space of the hard disk in the
directory assigned for the basic spool.
2. If the previous printing error not solved.
3. When expected to collide with other program.
4. When an application program or the printer
driver is damaged.
5. When some les related to OS are damaged
or virus infected.
6. Memory is less than suggested one.
1. Delete the unnecessary les to provide more space to start printing job.
2. If there are some les with the extension name of ****.jnl, Delete them
and Reboot the Windows to restart printing job.
3. Shut down all other programs except the current one, if possible.
4. Delete the printer driver completely and reinstall it.
5. After rebooting the computer, check for viruses, restore the damaged
les and reinstall the program to do the printing job.
6. Add up enough memory to the PC.
Description : The printing is not working properly even when the cable has no problem. (even after the cable is
replaced) If the printer won’t work at all or the strange fonts are repeated, the printer driver may be
defective or wrong setup in the CMOS Setup.
Description : To spool which stands for “simultaneous peripheral operations online” a computer document or task
list (or “job”) is to read it in and store it, usually on a hard disk or larger storage medium so that it can
be printed or otherwise processed at a more convenient time (for example, when a printer is nished
printing its current document).
How to delete the data in the spool manager.
In the spool manager, the installed drivers and the list of the documents waiting to be printed are shown.
Select the document to be deleted and check the delete menu.
If you intend to delete the current document being printed, the data being transferred to the printer will be put out
and then the document is removed. Before choosing the document, the menu is still inactive.
Or put the document out of the list and repeat the routine as in the above or nish the spool manager.