Samsung SCX-8030ND Series - Lamp

3.Replaceme
n
Perform the following procedure to remove the Lamp
To replace the lamp, you must first remove the scan
g
3.4.3 Lamp
1. Remove the 3 screws.
2. Remove the connector cover [A]. Remove 1 scre
w
[A]
3. Remove 2 screws.
[B]
Service Manual
SCX-8030/8040 series
3-
1
n
t Procedure
from the Scan Unit.
g
lass (3.4.1).
w
(ground harness). And unplug the connector.
4. Remove the rear cover [B] by slightly lifting up
and push back.
[B]
SAMSUNG ELECTRONICS
Version 0.05
1
3