Samsung SCX-8030ND Series - Fuser Unit

3.Replaceme
n
3.5 Fuser unit
This section contains the procedures for disassembli
n
Perform the following procedure to remove the Align
s
CAUTION
The temperature gets high in the vicinity of the fuser
replacing it, make sure that fuser unit has cooled.
[A]
Service Manual
SCX-8030/8040 series
3-
2
n
t Procedure
n
g the components of the printer Fuser Unit.
s
et from the Scan Unit.
1. Open the Cover-Side.
unit. When replacing it, you may get burned. Before
2. Remove 4 screws from the left/right.
3. Remove the fuser unit by holding the
handles [A].
SAMSUNG ELECTRONICS
Version 0.05
2
4