Samsung SCX-8030ND Series - Handling Precautions

1. Prec
a
1.2.3 Handling Precautions
The following instructions are for your own personal s
a
product.
(1) Ensure the printer is installed on a level surface ca
(1)
Ensure
the
printer
is
installed
on
a
level
surface
,
ca
cause the printer to tip or fall.
(2) The printer contains many rollers, gears and fans.
fingers, hair or clothing in any of these rotating de
v
(3) Do not place any small metal objects, containers
o
which if spilled could get into the machine and ca
u
(4) Do not install the machine in areas with high dust
o
a humidifier or heater. Dama
g
e could be caused t
o
1.2.4 Assembly / Disassembly Preca
u
g
(5) Do not place candles, burning cigarettes, etc on th
(6) When reinstalling the imaging unit or ITB unit at p
o
Replace parts carefully and always use Samsung par
t
cable routing before dismantling any part of the machi
Please carry out the following procedures before dism
(1) Check the contents of the machine memory and m
if the main board or network card is replaced.
(2) Ensure that power is disconnected before servicin
g
(3) Disconnect printer interface cables and power cabl
(3)
Disconnect
printer
interface
cables
and
power
cabl
(4) Only use approved spare parts. Ensure that part n
u
temperature rating are correct.
(5) When removing or re-fitting any parts do not use e
x
plastic.
(6) Take care not to drop any small parts into the mac
(7) Handling of the OPC Drum
-
The OPC Drum can be irreparably damaged if it e
-
The
OPC
Drum
can
be
irreparably
damaged
if
it
e
Take care not to expose the OPC Drum either to
d
room lighting. Exposure for as little as 5 minutes
c
properties and will result in print quality degradati
o
Remove the OPC Drum and store it in a black ba
g
working with the Covers (especially the top cover
)
damage the OPC Drum.
- Take care not to scratch the green surface of OP
C
If the green surface of the Drum Cartridge is scra
t
compromised.
Service Manual
SCX-8030/8040 series
1
-
1
-
a
utions
a
fety, to avoid injury and so as not to damage the
apable of supporting its weight Failure to do so could
apable
of
supporting
its
weight
.
Failure
to
do
so
could
Take great care to ensure that you do not catch your
v
ices.
o
f water, chemicals or other liquids close to the printer
u
se damage, shock or fire hazard.
o
r moisture levels, beside on open window or close to
o
the
p
rinter in such areas.
u
tions
p
e printer, These could cause a fire.
o
wer off, perform the OPC-ACR surely.
t
s. Take care to note the exact location of parts and
ne. Ensure all parts and cables are replaced correctly.
antling the printer or replacing any parts.
ake a note of any user settings. These will be erased
g
or replacing any electrical parts.
les
les
.
u
mber, product name, voltage, current and
x
cessive force, especially when fitting screws into
hine.
exposed to light
exposed
to
light
.
d
irect sunlight or to fluorescent or incandescent
c
an damage the surface of the photoconductive
o
n. Take extra care when servicing the printer.
g
or other lightproof container. Take care when
)
open as light is admitted to the OPC area and can
C
Drum Unit.
t
ched or touched the print quality will be
SAMSUNG ELECTRONICS
Version 0.05
-
3
-
3