Samsung SCX-8030ND Series - Electrical Components; Engine Controller

3.Replaceme
n
3.7 Electrical components
3.7.1 Engine controller
This section contains the procedures for disassemblin
Perform the following procedure to remove the Engine
1. Remove the rear upper cover [A] after removing 7 s
c
[A]
2. Slightly release 6 screws. It is not necessary to re
m
Move the rear shield [B] in the direction of the arrow (y
Move
the
rear
shield
[B]
in
the
direction
of
the
arrow
(y
[B]
Service Manual
SCX-8030/8040 series
3-
4
n
t Procedure
g the electrical components of the printer.
Controller PBA from the printer.
c
rews.
CAUTION
Observe precautions
For handling
Electrostatic
Sensitive
m
ove the screw completely.
yellow) Remove it
Sensitive
Devices
yellow)
.
Remove
it
.
SAMSUNG ELECTRONICS
Version 0.05
4
4