Samsung SCX-8030ND Series - Page 198

3.Replaceme
n
[E]
[F]
[G]
[G]
[G]
Service Manual
SCX-8030/8040 series
3-
8
n
t Procedure
5. Take off the holder-harness [E] after removing 3
screws.
CAUTION
When reassembling the holder-harness, make sure
the harness wiring is routed correctly
the
harness
wiring
is
routed
correctly
.
6. Remove the Top Right Motor [F] after removing 4
screws.
7. Remove the Top Left Motor [G] after removing 3
screws.
NOTE
To remove the Top Left Motor [G], first remove the
Top Right Motor [F].
CAUTION
When reassembling the Motor [G], be careful not to
lose the washer.
Washer
SAMSUNG ELECTRONICS
Version 0.05
8
8