Samsung SCX-8030ND Series - Finisher Adjustment

4.Servi
c
4.5.4.5. Finisher Adjustment
• Diagnostics > Adjustment > Finisher Ad
j
ust
m
Purpose To correct folding position of th
e
Operation
Procedure
1. Choose one item from the
• Booklet Folding Position –
G
• Booklet Folding Position –
G
• Booklet Folding Position –
G
• Booklet Folding Position –
G
2. Select one item and press t
h
3. Change the adjustment val
u
shown below. In
p
ut
–
value
p
Output Direction
Case 1
4. Press the “OK” button to ap
Verification Print out a booklet and check th
Specification
Group
P
ILT
II
A4
8.5 x 1
3
III
8.5 x 1
4
A3
LEDGE
R
Reference
IV
12 x 1
8
A
Lead
Edge
Lead
Edge
Service Manual
SCX-8030/8040 series
4-
3
c
e Mode
m
ent > Booklet Foldin
g
Position
e
booklet. Only available with Booklet finishers.
table. There are four items to choose.
G
roup 1 (Sheet Length < 288.0 mm)
G
roup 2 (288.0mm <= Sheet Length <358.5mm)
G
roup 3 (358.5mm <= Sheet Length <426.0mm)
G
roup 4 (426.0mm <= Sheet Length)
h
e edit button.
u
e with arrow button. Input + value in “Case 1”
in “Case 2” shown below.
Case 2
Output Direction
ply the new value to the system.
e folding position is located at the center.
P
aper Size
‘A’ Dimension
216 x 279
139.5 ± 1.5 mm
210 x 297
148.5 ± 1.5 mm
3
216 x 330
165.1 ± 1.5 mm
4
216 x 356
178.0 ± 1.5 mm
297 x 420
210.0 ± 1.5 mm
R
279 x 432
216.0 ± 1.5 mm
8
304.8 x 457.2
228.5 ± 1.5 mm
A
Folding
Line
Trail
Edge
SAMSUNG ELECTRONICS
Version 0.05
3
5