C7-1130 Waste toner container is full. Repla
C7-1311 Waste toner container is not installe
C9-2220 Transfer Roller Failure: #C9-2220. I
H1-1311 Paper jam in Tray 3
H1-1312 Paper jam in Tray 3.
H1-1317 Paper jam in Tray 3.
H1-1318 Paper jam in Tray 3
H1-1322 Tray 3 cassette is pulled out. Insert i
H1-1351 Paper is low in Tray 3. Load paper.
H1-1352 Paper is empty in Tray 3. Load pap
H1-1353 Input System Failure : #H1-1353. P
H1-1412 Paper jam in Tray 4
H1-1417 Paper jam in Tray 4.
H1-1418 Paper jam in Tray 4
H1-1422 Tray 4 cassette is pulled out. Insert i
Paper is low in Tray 4 Load paper
.
H1-1452 Paper is empty in Tray 4. Load pap
H1-1453 Input System Failure : #H1-1453. P
H1-3330 HCF Failure : #H1-3330. Check the
H1-5330 DCF Failure : #H1-5330. Check inte
ge.
H2-2002 Paper jam inside of finisher.
H2-2003 Paper jam inside of finisher.
H2-2005
Paper jam at entrance of finisher bri
H2-2008 Paper jam at entrance of finisher.
H2-2009
Paper jam at exit of finisher.
H2-2010 Paper jam at exit of finisher.
H2-2012
Paper jam inside of finisher bridge.
H2-2014 Paper jam around puncher of finish
H2-2129
Finisher Error #H2-2129. Please op
Service Manual
SCX-8030/8040 series
7
stall transfer roller again.
7-38
7-39
7-39
7-39
7-39
t properly.
7-40
7-41
ll Tray 3 out and insert it.
7-43
7-39
7-39
7-39
7-39
t properly.
7-40
ll Tray 4 out and insert it.
7-43
HCF connection.
7-44
rnal DCF connection.
7-44
Refer to Finisher SM
Refer to Finisher SM
Refer to Finisher SM
ge.
Refer to Finisher SM
Refer to Finisher SM
Refer to Finisher SM
Refer to Finisher SM
Refer to Finisher SM
n/close door.
Refer to Finisher SM
SAMSUNG ELECTRONICS
Version 0.05