8. Deverope Process
▶
Developing Method : Non magnetic 1 element contacting method
▶
Toner : Non magnetic 1 element shatter t ype toner
▶
TonerQty:35gf/60gf(1k/3k)
▶
The life span of toner 1k/3k sheets (ISO 5% Coverage )
▶
Toner Residual Sensor : None
▶
OPC Cleaning : Use the conventional cleaning blade
▶
Handling of wasted toner : Discard by collecting waste-toner at waste-toner bin.
▶
OPC Drum Protecting Shutter : None
▶
Classifying device for toner cartridge: ID is classified by interruption of the frame
channel.
▶
Development Roller type : conductive elastic roller
▶
Doctor BLADE Type : Regulating toner layer by pressure
▶
Charge Roller Type : Conductive Roller Contact-Charge
9. Sanner Part
600dpi Color CIS Module for Flat bed
,
SCX-4517F uses the CIS scanning method
1) CIS SPEC
▶
Scanning size : 216 mm ( width for letter-size)
▶
Light source : LED
▶
Scanning sensor: CIS 600/300 dpi
▶
Scanning mode : Color SCAN / Mono SCAN
▶
MTF : 30% (300 dpi Chart)
▶
CIS interface : Analog output
▶
Power supply : 3.3V
▶
Clock Frequency: 5.5MHz max.
▶
Number of output : 1
▶
LED Current : Green/Blue : 50mA, Red : 60mA
▶
Clamp Level : 1.4V
▶
Connection : 12 pin FFC connector (pitch 1.0mm)
2) Scan Resolution
(a) Translation
▶
Normal : Vertial: 3.85 Line/mm, Horizontal: 8 Pels/mm :203 x 98dpi
▶
Fine : Vertial: 7.7 Line/mm, Horizontal: 8 Pels/mm :203 x 196dpi
▶
Super Fine : Vertial: 11.8 Line/mm, Horizontal: 11.8 Pels/mm ;300 x 300dpi
To Next Page
Loading...
