Troubleshooting for Anynet+
!
i_!_!i!_i:_ii!i!iiiil_i_!_!_!_!_!_i!_i:!:!_!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i!!i_i!_i!_i!_i!_i!_i!_i!_i_!_!!_i!_!_!_!_i_i_i_!_i_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii!ii_i_i_i_i_i_iii_i_iii!!i_iii!_!i!_i_i_i_i_i_i_i!i!_i!!_!_!i_i_i_
Anynet+ does not work. • Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devicesonly.
• Only one receiver (home theater) can be connected.
• Check if the Anynet+ device power cord is properly connected.
• Check the Anynet+ device'sVideo/Audio/HDMI cable connections.
• Check whether Anynet+ (HDMI-CEC) isset to On in the Anynet+ setup menu.
• Check whether the TV remote control isin TV mode.
• Check whether the remote control isAnynet+ compatible.
• Anynet+ doesn't work in certain situations. (Searching channels, operating Media Play or Plug & Play (initial
setup), etc.)
• When connecting or removingthe HDMI cable, please make sure to searchdevices again or turn your T_/off
and on again.
• Check if the Anynet+ Function of Anynet+ device is seton.
I want to start Anynet+. • Check if the Anynet+ device is properly connected to the T_/and check ifthe Anynet+ (HDMI-CEC) isset to
On in the Anynet+ Setup menu.
• Pressthe TOOLS button to display the Anynet+ menu and select a menu you want.
I want to exit Anynet+. • Select View rv in the Anynet+ menu.
• Pressthe SOURCE button on the TV remote contrel and select a non- Anynet+ device.
• Press v CH A, PREoCH, and FA_LCHto change the TV mode. (Note that the channel button operates
only when a tuner-embedded Anynet+ device is not connected.)
The message "Connecting to • You cannot use the remote control when you are configuring Anynet+ or switching to aview mode.
Anynet+ device..." appears on the • Use the remote control when the Anynet+ setting or switching to view mode iscomplete.
screen.
The Anynet+ device does not play. • You cannot use the playfunction when Plug & Play (initialsetup) is in progress.
The connected device is not
displayed.
o
o
o
o
o
o
The TV Program cannot be •
recorded.
The TV sound is not output • Connect the optical cable between T_/and the receiver.
through the receiver. • The ARC function enablesdigital output of sound using the HDMI IN 2(ARC} port and can only be operated
when the TV is connected to an audio receiverthat supports the ARC function.
Check whether or not the device supports Anynet+ functions.
Check whether or not the HDMI cable is properly connected.
Check whether Anynet+ (HDMI-CEC) isset to On in the Anynet+ setup menu.
Search Anynet+ devices again.
You can connect an Anynet+ device using the HDMI cable only. Some HDMI cables may not support Anynet+
functions.
Ifconnection isterminated because there has been a power interruption or the HDMI cable has been
disconnected, please repeat the device scan.
Check whether the antenna jack on the recording device isproperly connected.
English 45
To Next Page
Loading...
