hputCables (Sold Separately)
See separate guide for installing the stand.
_ 9a/M4xLs/
_} 8ia 8 ai _ :
Follow the steps below to connect the TV to the stand.
Screws(M4X LS)...... _ Ty T Topview
Stand -..--..\_., E Front i
1. Connect the Guide Stand to the Stand using four screws (M4 X L8) as shown.
2. With your TV upright, connect the TV to the Stand as
shown.
Screws(M4X LS)---_
3. Fasten two screws (M4 X LS) at position _, and then
fasten three screws (M4 X L8) at position _.
NOTE
* Make sure to distinguish between the front and back of the Stand and Guide Stand when assembling them.
* Make sure that at least two persons lift and move the LED TV.
* Stand the product up and fasten the screws. If you fasten the screws with the LED TV placed down, it may lean to
one side.
English 5
To Next Page
Loading...
