11. Turn off the phone and put a non working sim in the phone (enter
PIN if requested)
12. Connect phone with computer using original Samsung USB cable
13. Run Samsung Remote Unlock Client (Start -> Programs -> Simlock
Remote Client -> Samsung Remote Unlock client)
14. Login using your SRS login
15. Select your phone model from the drop down list
16. Press rescan and make sure 'DiagPort' is detected (In case of trouble
Check and set Samsung OMAP modem port
)
1. Make sure your original Samsung USB cable is connected to
your computer and your phone (turned on in correct mode)
2. Open 'Device Manager' on your computer:
On XP go to: Start -> Settings -> Control Panel -> (Switch to
Classic view ) -> System -> Hardware (tab) -> Device Manager.
On Vista go to: Start -> Type in the following commando in the
Page 9/13 Copyright 2006 - 2016 UnlockSamsungOnline.com