Learn to connect via an access point (AP) when you are in a range of a
WLAN. You can also configure network settings.
Connecting to a W N
Rotate the mode dial to WioFi.
Select @, _, @, _, or _.
Press [MENU], and then sebct Wi°Fi Setting.
o In some modes, press [MENU]or foltow the on-screen
instructions until the Wi-Fi Setting screen appears.
o The camera automatically searches for available AP devices.
Select an AR
Refresh
Samsung 2 (c_)) "@"
Samsung 3 _ I_1
Samsung 4 _ I_ "_"
Refresh Refreshconnectable APs.
(c_) Ad hoc AP
Secured AP
WPS AP
_"_. Signal strength
WPS button connection Connect to a WPS AR
Add wireless network Add an AP manually.
o Press [Fn] to open network setting options.
o When you select a secured AR a pop-up window appears. Enter
the required passwords to connect to the WLAN, For information
about entering text, refer to "Entering text". (p. 105)
o When a Iogin page appears, refer to "Using the Iogin browser".
(p. 10S)
o When you select an unsecured AR the camera will connect to the
WLAN.
If you select a WPS profile supported AR select WPS PIN
connection, and then enter a PiN on the AP device. You can
also connect to a WPS profile supported AP by selecting WPS
button connection on the camera, and then pushing the WPS
button on the AP device.
To Next Page
Loading...
