Screen
•
PC Position
Adjust the PC’s screen positioning if it does not fi t the
Monitor screen.
1. Follow the "Image Lock" instructions number 2 to 4.
2. Press the
/
the ENTER button.
3. Press the
/
button to adjust the Vertical-Position.
Press the
/
button to adjust the Horizontal-Position.
Press the ENTER button.
4.
Press the MENU button to exit.
•
You can replace all image settings with the factory
default values.
1. Follow the "Image Lock" instructions number 2 to 4.
2. Press the
/
button to select "Image Reset",then
press the ENTER button.
3.
Press the MENU button to exit.
USER'S MANUALUSER'S MANUAL
- 10 -
USER'S MANUAL
PC Position
Move Enter Return
Screen
Image Lock
PC Position
Image Reset
Move Enter Return
SMT-1722-1922-Eng.indd 1:15 2009-7-16 10:57:10
button to select "PC Position",
then press
In VGA Mode, "Sharpness" can not be adjusted.
Image Lock , PC Position , Image Reset
•
Image Lock(Coarse and Fine Tuning of the Image)
The purpose of picture quality adjustment is to
remove or reduce picture noise.
If the noise is not removed by Fine-tuning alone,
then adjust the frequency as best as possible
(coarse) and Fine-tune again.
After the noise has been reduced, re-adjust the
picture so that it is aligned on the center of screen.
1. Preset: Press the SOURCE button to select VGA
mode.
2. Press the MENU button to select the
Picture menu.
3. Press the ENTER or
button.
4. Press the
/
and ENTER button to select the
Screen menu.
5. Press the
/
to select "Image Lock",then press the
ENTER button.
6. Press the
/
button to select "Coarse" or "Fine",
then press the ENTER button.
7. Press the
/
button to adjust the screen quality.
Press the ENTER button.
8.
Press the MENU button to exit.
Screen
Image Lock
PC Position
Image Reset
Move Enter Return
Image Lock
Move Enter Return
Image Reset (Initializing the Image Settings)
Only in VGA Mode, "Screen" can be adjusted.
Coarse
Fine
50
63
To Next Page
Loading...
