setup screen
To use Video analytics
It detects event that meets all conditions specified by sensitivity, size and area and the
event condition rules.
1. Select the video analysis mode.
2. Set <Sensitivity>, <Size> and <Area>.
For further details on settings, refer
to “To use Motion detection”. (Page
100~101)
3. Select <Analytics> tab.
4. Select the video analysis type.
• Passing, Entering/Exiting : Detects
motions of passing, entering into or
exiting from a virtual line specified by
the user.
• Appearing (Disappearing) : Detects
motions of appearing on or
disappearing from the user-defined
area or the entire screen area.
5. Set the video analysis rules.
For further details on settings, refer to
“To set the video analysis rules”.
(page 103~104)
6. Set whether to use <Detection result
overlay>.
Specified rules of virtual lines and areas
are displayed on the monitoring page.
7. When done, click [Apply (
)].
102_ setup screen
To Next Page
Loading...
