setup screen
56_ setup screen
To add a preset
1) Select the preset number to add.
2) Set the name for the preset.
3) Press the [
] button.
To delete a preset
1) Select the preset number to delete.
2) Press the [ ] button.
To move a preset
1) Select a preset number that you want to move.
2) Press the [ ] button.
6. Specify the serial port.
You can set the RS-485 communication mode for pan/tilt-compliant receiver that is
connected to the network camera.
• Protocol : Select one from SAMSUNG-T/ SAMSUNG-E / PELCO-D/ PELCO-P/
SUNGJIN.
• Camera ID : Provide a camera ID.
• Baud rate : Transfer rate for RS-485 communications
• Data : Specify the data bit.
• Parity : Specify the parity bit.
• Stop bit : Specify the stop bit.
M
All these operations above mentioned will be enabled only if the network camera is properly
connected to the pan/tilt-compliant receiver. And the serial port for the pan/tilt operations should
be properly specified.
J
The baud rate may not be controlled depending on the product specifications.
7. When done, click [Apply
( )
].
To Next Page
Loading...
