English _63
● SETUP SCREEN
QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <QoS>.
3. Provide the IP address.
The default prefix is 32. For DSCP, the
default is set to 63.
4. Select an IP address to which you will
apply QoS.
Only the selected IPs can be prioritized.
5. When done, click [Apply (
)].
SNMP
You can configure the settings for the SNMP protocol.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <SNMP>.
3. Specify the <SNMP>.
• Enable SNMP v1 : SNMP version 1
will be active.
• Enable SNMP v2c : SNMP version 2
will be active.
- Read Community : Read
community where you can access objects that support the SNMP protocols.
- Write Community : Write community where you can access objects that support
the SNMP protocols.
• Enable SNMP v3 : SNMP version 3 will be active.
- Password: Specify the default password for SNMP version 3.
4. When done, click [Apply (
)].
J
SNMP v3 is only able to be set when the secure connection mode is HTTPS.
To Next Page
Loading...
