Samsung SR-S2026C - Page 41

@
When
“Beep-Beep”
sound
continuously
occurs
Isn’ t forced
operation or defrost
elected?
Cancel forced operation or
defrost.
MAIN-PCB is normal
Does buzzer
sound occurs if power
is reset?
Check dirt insertion and short on test
jumper part inside of the MAIN-PCB
+
Sound
of
“Beep-Beep”
does
not
occur
except
abnormalities
due
to
forced
operation,
defrost
or
self-diagnosis
abnormality.
*
In
case
of
self-diagnosis
abnormality,
it
is
easy
to
check
because
it
is
indicated
on
panel-display.
If
“Beep-Beep”
sound
continues
to
ring
though
panel
display
is
normal,
it
is
considered
that
forced
operation
or
defrost
is
selected.
@ Incase PANEL-DISPLAY is not lit
fs connector
insertion of HINGE-UP cover
normal?
Re-insert connector, repair
badness on contact
Re-insert connector inside
of the MAIN-PCB.
Re-insert connector, repai
badness on contact.
Is insertion of MAIN-PCB
connector(CN50) normal?
i.
Y
Replace PANEL-DISPLAY |