Samsung SR-S20NTC - Page 24

5) The following are examples for use.
in case of selecting vacation function only
If you press “vacation” button, Refrigerator will not operate and freezer will operate
only. In case you Select this function, take out all foods in the Refrigerator. And “ice
Off” is automatically selected among ice modes, so ice bucket should be empty and
water supply valve should be turned off.
In case of selecting ice timer function only
In case you press “Ice Timer” button to select date as explained above, and not
selecting “Vacation” function so that Refrigerator continues to operate, ice mode is
selected as “Ice Off” and ice is stored in the bucket when you return. Therefore, do
not lock the water supply valve.
In case of selecting both vacation and ice timer function
In case you press “Ice Timer” button and “Ice Timer” button to select date to select
date as explained above, or if you press “Ice Timer” button to select date and press
“Vacation” button afterward, Refrigerator does not operate but freezer operates only,
and ice mode is automatically selected as “ice Off”. So you must take out all foods in
Refrigerator, empty ice in the ice bucket, check water leakage on valves, other hoses
and connection parts without locking water supply valve. When “Vacation” function is
cancelled, Refrigerator resumes its operation.
@ Ice Dispenser Function (Cover Ice Route Solenoid Valve)
1) After 8sec. from initiai power on, solencid of ice exit operates once. This is the
function to prevent interruption of electric service when ice exit is open. So this is not
a defect.
2) With turning the dispenser S/W from on to off and ice ejecting is
completed, 5sec. after turning off S/W, ice exit is closed because. cover ice
route solenoid of ice dispenser operates.
@ Water Dispenser Function
1) This function is a system of direct connection with water supply. When water lever is
pressed, water solenoid valve which is equipped at the right side of machine room
opens so as to operate to eject water. However, it has no function to conirol on
Micom PCB. Therefore, if there happens any defect at water eject function, check
and repair solenoid itself, wire connecting connector, connecting tube and state of
water supply.
©) Water Filter Indicator Function
1) After the initial power on, indication lamp is displayed in green light. After 5 months
passed, it is displayed in orange light, and 1 month after this, it is displayed in red
light. This is memorized by EEPROM in Micom PCB, so it counts the passed time
continually though the power is turned on again after it was turned off.
2) If you press ice selecting button and ice-making stop button at the same time for
25sec. continuously, indication lamp lights in green color. And it becomes orange
after 5 months from this moment. And it displays red after 1 month from the
moment.
3) If you press ice selecting button and ice-making stop button at the same time for 5
sec., indication lamp is turned off and water filter indicator function stops. At this
moment, passed time is not counted.
4) At the state where the function is stopped, if you press ice selecting button and ice-
making stop button at the same time for 25sec. continuously, “Green” light is turned
on and water filter indicator function will resume. And it becomes orange light after 5
months from this moment. And it displays red light after 1 month from the moment.