Samsung SR-S25NTA - Page 119

10. Check the amount of supplied-water to the ice maker.
1) Remove the upper ice maker
frome the refrigerator.
2)
When
the
test
button
is
pressed,
the
ice
cube
container
is
tured
and
then
water
is
out
from
the
tap
of
the
ice
maker
where
water
is
wupplied.
At
this
time,
check
the
amount
of
water.(see
the
picture)
If
there
is
over-supply
of
water,
the
ice
cube
will
be
made
in
attached
form
of
2
to
4
ice
cubes,
If
there
is
less-supply
of
water,
the
ice
cube
will
be
made
in
small
size.
When
this
happens,
you
may
encounter
inconvenience
while
using.
This
is
not
a
problem
in
the
refrigerator.
It
is
the
problem
of
water
pressure
in
the
water
pipe
and
occurs
frequrently.
When
this
problem
occurs,
control
the
amount
of
water
supply
by
the
following
method.
CHECK OF THE SUPPLIED WATER
al.
{The Method to control the amount of water supply to the ice maker)
1. Disassemble the PCB panel at the top of he refrigerator.
CROSS DRIVER(+)
STRAIGHT DRIVER(-)
2. Using the water controlling SM, control the amount of water supply.
= Option to control water-supply time
SWITCH NO
SR-S24FTA
<—
| ON | OFF | OFF | 5 Seconds * The amount of water supply depends upon
7 Seconds the set time and the water pressure(water
- pressure for home use). :
* If th ice cube is small, it may be caused by
less supply of water. So, increase the water-
: | OFF | OFF | ON | cape ass example : change the time
from 6 seconds to 7 seconds).
* If ice cubes are attached each other because
of over-supply of water, decrease the
“.water-supply time(for example : change the
time from 6 seconds to 5 seconds).
power switch of the refrigerator must be
turned off and then turned on again.
(Otherwise, the change will not work.)
* When the refrigerator is marketed, the
water-supply time is set to 6 seconds.
Switch ON
Switch OFF
Notice
a8
MODEL NAME | * After change of the water-supply time, the ©
3. If S/W control is completed, check the amount of supplied water to the
Ice Maker.
CHECK OF THE AMOUNT OF
WATER SUPPL’
* If the controlled amount of water supply is slightly below
the optimum level, it doesn’t matter for use.
4. If the amount of water supply is not enough, reset the S/W.
(Read item 2 and 3). If the setting is completed in accordance with water
pressure in the pipe, reassemble the PCB panel.
CROSS DRIVER(+)
‘eo
WATER CONTROLLING S/W Yr ~~] When setting the amount of water supply,
; Jo. q do not select the large amount of water
4a UY supply from the beginning. Set step-by-step.
bie (Water can be over flowed)
—118-