SATA HDD INSTALLATION
1. Insert rubber rings to the bracket and screw the bracket to the HDD.
2. When assemble the SATA converter board, screw on the only upper-right corner
like the picture below.
3. Select "Master" or "Slave" using the Jumper switch on SATA converter board.
Set the Master/Slave using the Jumper switch.
Set the Master/Slave using Jumper switch.
JUMPER Switch
In case of installing two HDDs, rstly set the Master/Slave. If One HDD is "Master", the other
should be set to "Slave".
Need assy Screw
To Next Page
Loading...
