1. When starting the system for the first time, the Thin Client Setup Wizard is launched as
shown below. If
Next
is not clicked during the 15 second countdown after the first 30
seconds, all settings are configured to the factory defaults and the setup wizard is exited.
2. When entering a terminal name and clicking on
Network Properties
, the
Network
Manager
dialog box is displayed. This dialog box shows a list of adapters installed on your
terminal. You can change the properties of an adaptor, such as the IP address and name
server, by clicking on
Properties
.
Click
Next
to proceed to the next step.
To Next Page
Loading...
