Samsung UE65KS9502T - Page 14

3-10
3. Disassembly and Reassemble
Description & Screws Picture Description
14
Remove the Screws on LD(Local Dimming)
Board, and then remove the board. (FFC Cable
was already removed)
78" : 6 EA•
15
Remove T-Con Board.
Gently lift out 4 corners of the board to •
release its locks (Locking
).
Use both hands to hold the board and slide it •
toward the upper side to remove. (It's easier
foryoutousebothhands-amiddlenger
for upper side and a thumb for bottom side
to lift and slide out simultaneously.)
Locking
16
Removing ASSY PCB MAIN BOARD.
Gently lift up (Top Right corner) to release the •
lock (Locking
).
Use both hands to hold (Bottom chassis •
Guide Fixing Hole
) the board and slide to
the left to release the board.
NOTE
When installing the ASSY PCB MAIN BOARD,
verify the board is properly positioned in all 4
mounting slots.
Bottom chassis Guide Fixing Hole
Locking
NOTE
Reassembly procedures are in the reverse order of disassembly procedures.