3-2
3. Disassembly and Reassemble
Description & Screws Picture Description
4
Insert the Samsung Service Jig at the indicated
positions (Holes) to release bottom corners of
the ASSY COVER REAR.
SVC JIG-ASSY MISC P-JIG
BN81-12884A
SVC JIG-ASSY MISC P-JIG (Holes)
5
Release the Hooks at each point (Side: 16
points) indicated by Yellow Circles along side
line of the rear cover using the Service tool as a
lever.
NOTE
Not to make Clips (molds of the upper side
locked up on the Bottom Chassis) damaged,
use the service tool only from the bottom
corner to the point (indicated as the Red lines)
apart from the upper side by about 7cm.
7cm
6
Gently lift up the Rear Cover from the bottom
side and then push it toward the upper direction
of TV as the below photo to release all mounting
clips located along the upper side of the Rear
Cover as indicated by Yellow Circles.
1
2
To Next Page
Loading...
