Warranty
Information
Federal Communication Commission
Interference Statement
This equipment has been tested and found
to
comply
with the limits for a Class B digital
device, pursuant
to
Part 15
of
the FCC Rules.
These limits are designed
to
provide reasonable
protection against harmful interference
in
a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used
in
accordance with
the instructions, may cause harmful interference
to
radio communications. However, there
is
no
guarantee that interference will not
occur
in
a
particular installation. If this equipment
does
cause
harmful interference
to
radio
or
television reception,
which can be determined by turning the equipment
off and on, the user is encouraged
to
try
to
correct
the interference by one of the following measures:
• Reorient
or
relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into
an
outlet on a
circuit different from that
to
which the receiver
is
connected.
• Consult the dealer
or
an experienced radio/TV
technician for help.
FCC Caution: Any changes or modifications not
expressly approved
by
the party responsible for
compliance could void the user's authority
to
operate this equipment.
This device complies with Part 15
of
the FCC
Rules. Operation
is
subject
to
the following
two
conditions:
(1)
This device may not cause harmful
interference, and
(2)
this device must accept any
interference received, including interference that
may cause undesired operation.
For
product
available
in
the USA/Canada market,
only channel
1-11
can be operated. Selection of
other channels
is
not possible.
This device and its antenna(s) must not be
co-
located
or
operation
in
conjunction with any other
antenna
or
transmitter.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance
20cm
between the radiator & your body.
This Class 8 digital apparatus complies
with Canadian ICES-003.
Cet appareil numerique
de
Ia
classe B conforme a
Ia
norme
NMB-003
du Canada.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation
is
subject
to
the following
two
conditions:
(1)
this device may not
cause interference, and
(2)
this device must accept
any interference, including interference that may
cause undesired operation of the device.
Le present appareil est conforme aux CNR
d'lndustrie Canada applicables aux appareils radio
exempts
de
licence. L'exploitation est autorisee
aux deux conditions suivantes:
(1)
I'
appareil ne
doit pas produire de brouillage, et
(2)
l'utilisateur
de
I'
appareil
do
it
accepter
tout
brouillage
radioelectrique subi,
meme
si
le brouillage est
susceptible
d'en
compromettre
le
fonctionnement.
For product available
in
the USA/Canada market,
only channel
1-11
can be operated. Selection of
other channels
is
not possible.
This device and its antenna(s) must not be co-
located or operation
in
conjunction with any other
antenna or transmitter.
Under Industry Canada regulations,
this radio
transmitter may only operate using an antenna
of
a type and maximum (or lesser) gain approved
for the transmitter by Industry Canada.
To
reduce
potential radio interference
to
other users, the
antenna type and its gain should be so chosen that
the equivalent isotropically radiated
power
(e.i.r.p.)
is
not more than that necessary for successful
communication.
IC Radiation Exposure Statement:
This equipment complies with
IC
RSS-1 02 radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance
20cm
between the radiator & your body.
To Next Page
Loading...
