Before Using the Recording and Timeshift Functions
Before using the recording and schedume recording functions
Recor_ding is not suppor_ted in the U_S_Aand Canada_
o To set up a Schedule Recording, you must first set the TV's clock. Set the Clock (IMIEINLJ>
System > Time > Clock).
o You can set up a maximum total of 30 Schedule Viewin9 and Schedule Recordin9 entries.
o Recordings are DRM-protected and therefore cannot be played back on a computer or on a
different TV. In addition, these files cannot be played back on your TV if its video circuit has
been replaced.
o A USB hard drive with a speed of 5,400rpm or above is recommended. However, RAID-type USB
hard drives are not supported.
o USB memory sticks are not supported.
o The total recording capacity may differ with the amount of available hard drive space and the
recording quality level.
o Schedule Recording requires at least 100MB of free space on the USB storage device. Recording
will stop if the available storage space falls below 50MB while recording is in progress.
o If the available storage space falls below 500MB while both the Schedule Recording and
Timeshift functions are in progress, only the recording will stop.
o The maximum recording time is 720 minutes.
o Videos are is played according to the TV settings.
o If the input signal is changed while recording is in progress, the screen will go blank until the
change is made. In this case, recording will resume, but • will not be available.
o When using the Record or Schedule Recording function, the actual recording may start a second
or two later than the specified time.
o If the Schedule Recording function is operating while a recording is being made on an HDMI-
CEC external device, the priority is given to the Schedule Recording.
o Connecting a recording device to the TV automatically deletes abnormally saved recording files.
o If the Off Timer or Auto Power Off has been set, the TV will override these settings, continue to
record, and turn off after the recording has ended.
To Next Page
Loading...
