2-7-2. Setting up Internet@TV
Settings
Create IDs and congure Internet@TV settings from this screen.
Highlight Settings using ◀ and ▶ buttons and press the ENTER button.
Account Login
Ticker Autorun may not be supported depending on country.
Ticker Autorun (O / On): Enable/disable ticker autorun upon powering on the TV.
Channel Bound Service (O / On): Some channels support widgets as an Internet data service, allowing you to access
the Internet service while watching TV.
Only available if supported by the broadcaster.
Reset: Resets Internet@TV settings to factory default settings.
Change the Service Lock password
The default password set is “0-0-0-0.”
If you forget the password, press the following sequence of remote control buttons to reset the password to
“0-0-0-0”: POWER (o) MUTE 9 2 8 POWER (on).
Internet@TV ID
You can use this menu when creating, deleting the account. You can control your account including contents site’s account
information.
Account is only for internet@TV.
Create: Create an account and link it with desired service widgets.
Note
Account will be made less than 10.
Maximum number of characters is 10.
Manager
- Service Site: Register login information for service sites such as YouTube.
- Change Password: Change account password.
- Delete: Delete the account.
If you forget the password, press the following sequence of remote control buttons to reset the password to
“0-0-0-0”: POWER (o ) MUTE 9 2 8 POWER (on).
Service Manager
Delete and lock widgets installed to Internet@TV.
Lock : Lock the widget
Accessing a locked widget requires the password.
Delete: Delete the widget.
Properties
Display information about Internet@TV. Use the Check the speed of your internet connection option to test your network
connection.
To Next Page
Loading...
