▶
English
▶
❑
Switching between Anynet+ Devices
1. Press the TOOLS button, select Anynet+ (HDMI-CEC), and then press
ENTER
E
.
2. Select Device List, and then press the ENTER
E
button.
N
If you cannot find a device you want, select Refresh to refresh the list.
3. Select a device, and then press the ENTER
E
button. You can switch to the
selected device.
N
The Device List menu appears only when you set Anynet+ (HDMI-CEC) to
On in the System menu.
●
Switching to the selected device may take up to 2 minutes. You cannot
cancel the operation during the switching operation.
●
If you have selected an Anynet+ device by pressing the SOURCE button
and then selecting its input source, you cannot use the Anynet+ function.
Make sure to switch to an Anynet+ device by using the Device List.
To Next Page
Loading...
