Samsung UN40D5550RF - Included Accessories and Cables; List of Included TV Accessories; Optional Input Cable Information

[St 6]
If OK TV ill t ff
Step2. How to upgrade the Firmware
[Step 1] Turn on TV to upgrade.
[Step 2] Insert the USB Memory Drive
containing the firmware into the USB
po
rt
o
f TV.
[St
ep
6]
If
press
OK
,
TV
w
ill
t
urn o
ff
automatically after showing below
message.
TV will restart automatically for software
d
po o
[Step 3] Press the MENU button, select
‘Support’, ‘Software Upgrade’. Then press
‘By USB’.
upgra
d
e.
OK
[Step 7] After TV turns on again,
u
pg
rade starts.
[Step 4] The message “Scanning for USB.
This may take more 1 min.” is displayed.
pg
Upgrading...
Please do not disconnect the USB until upgrade is
completed. TV will automatically restart after
completing upgrade.
80%
[Step 8] When the firmware upgrade
is complete, the TV will turn off and
then back on by itself.
Scanning for USB.
This may take more than 1 min.
[Step 5] If TV finds valid version, it
Shows below message.
Valid version found in the My USB device.
Upgrade version 000000 to version 001007?
The system will be reset after upgrade.
Upgrade is completed.
OK
OK Cancel