English - 10
Initial Pairing
1. When the user inserts batteries into the QWERTY Remote, "NEED PAIRING PRESS SYM+TAB” will be displayed on the
screen.
2. Press the SYM and TAB buttons at the same time for more than 2 seconds.
✎
The TV can be paired with only one QWERTY remote. Start the pairing process approximately 30 seconds after turning
on the TV.
✎
Keep within 20 inches(50 cm) between the QWERTY Remote and the TV.
Performing the Pairing Process Again
1. If the QWERTY Remote has been paired before, press @ and ← on the QWERTY side for more than 3 seconds.
"RESET OK" will be displayed on the LCD screen of the QWERTY remote.
2. Press MUTE, 0, MUTE and 0 on the remote side of the QWERTY Remote as it faces the TV. This sequence must be
completed within 4 seconds.
✎
There might be a slight delay between input and the response from the OSD. Do not wait for visual confirmation on the
screen.
3. Follow the initial pairing process within 3 minutes. If the initial pairing process does not finish within 3 minutes, the whole
process must be performed again.
Connecting to an Antenna or Cable Connection
Connecting the power cord and an antenna or cable connection
✎
For the best cable connections to this product, be sure to use cables no thicker than 0.55 inches (14mm).
ANT OUT
VHF/UHF Antenna
or
Cable
Antenna Cable (Not Supplied)
x
Maximum thickness - 0.55 inches (14mm)
[UD7000-NA]BN68-03435A-03L03.indb 10 2011-03-14 오후 6:44:56
To Next Page
Loading...
