BN68-05037A-01
QUICK START
GUIDE
Welcome to your new Smart TV!
The following instructions cover assembling, connecting, and setting up your new TV. Make
sure you have the accessories listed below.
Included in this box
Remote Control Stand Parts and Cables
x 2
Smart Touch Control Screw Cover Power inlet cover Cable clip
x 2
Batteries (AAA x 2) Wall mount adapter TV holder kit Power cord
RCA Adapter x 2 Component adapter IR extender
Also included: User manual, regulatory guide, 3D Active Glasses
Step
1
Attach the TV to
the Stand
Step
2
Connect video
devices
Step
3
Insert the
batteries into the
remote control
Step
4
Power on and
start the initial
setup
Warning: Screens can be damaged
from direct pressure when handled
incorrectly. We recommend lifting the
TV by the edges, as shown.
Step 1 Attach the TV to the Stand
1
Open the package, and take the cushioning out
of it.
5
Lay the TV on a soft surface, screen side down.
Use the packing material to protect the screen.
REQUIRED TOOLS: a Phillips head screwdriver and a soft, flat surface larger than the TV
(such as the box).
6
Holding the stand parallel to the screen, slide the
stand legs into the notches on the back of the TV.
2
x 2
Leg
Base Screws
x 8
Put a base, legs and screws off to assemble the
stand out of the box.
3
x4 (M4 X L12)
L
R
Fit the base and legs together, making sure that
the legs are firmly aligned with the base. See the
diagram below.
7
x4 (M4 X L12)
Insert 4 screws and secure the stand to the TV.
4
Insert 2 screws through the base into each leg as
shown, and then secure the legs to the base with
a screwdriver.
8
When placing the product on a console or shelf,
make sure that the stand does not protrude
out of the console or shelf. This may cause the
product to fall off and result in a malfunction or
injury.
[UF8000_QSG]BN68-05037A-01ENG.indb 2 2013-03-22 �� 10:34:16
To Next Page
Need help?
General
Weight and Dimensions
