How to know it is from Main Board or T-CON when some problems happen
No Video•
If the problem is No Video but BLU is on and Indication LED is blinking repeatedly and faster than nomal booting, replace
the T-CON board.
Distorted Picture•
Check the inner patterns.
Enter the service mode 1. ⇢ Choose ‘SVC’ ⇢ Check the ‘internal pattern.’
Enter ‘Service Mode.’2.
If you do not have Factory remote control -
Power OFF MENU 1 8 2 Power On
If you have Factory remote control -
INFO Factory
Choose ‘SVC.’3.
Choose ‘Test pattern.’4.
Select the each pattern and then check all pattern is ok or not.5.
Option
Control
SVC
Expert
ADC/WB
Advanced
Test Pattern Mstar Test Pattern
Picture Problem Solution
OK Main Board Change the Main Board
NG Panel and T-CON Board Change the Panel or T-CON
To Next Page
Loading...
