Operations
English46
Operations
• Make sure the lid is closed tightly before you start a load of laundry.
Delay End
You can set the washer to nish your wash automatically at a later time by choosing a
delay of between 1 to 24 hours (in 1 hour increments). The hour displayed indicates the
time the wash will nish.
1. Select a cycle. Then, change the cycle settings if necessary.
2. Press Delay End repeatedly until a desired end time is set.
3. Press and hold Start/Pause (Hold to Start) .
4. To cancel Delay End , restart the washer by pressing Power .
Real-life case
You want to nish a two-hour cycle 3 hours from now. To do this, you add the Delay End
option to the current cycle with a 3-hour setting, and then press and hold
Start/Pause
(Hold to Start)
at 2:00 pm. The washer starts operating at 3:00 pm and ends at 5:00 pm.
Provided below is the time line for this example.
2:00 pm
Set Delay End to 3 hours
3:00 pm
Start
5:00 pm
End
Alarm Off
You can turn the alarm sound on or off. When the alarm is off, the cycle completion
melody and the power-off beep will not sound. However, button and alert sounds will
remain on.
• To mute the alarm sound, press and hold
Super Speed for 3 seconds.
• To unmute the alarm sound, press and hold again for 3 seconds.
• Your setting will be kept even after you turn off and then restart the machine.
Untitled-6 46Untitled-6 46 2021-05-25 8:26:402021-05-25 8:26:40
To Next Page
Loading...
