Tighten the lock nut after
the leveling. If not, it
could generate vibrations &
noises.
Lock Nut
Leveling Bolt
Spanner
Flat Head
Screwdriver
■ How to Level the Unit
1.Select an installation place.
Install the unit with 10cm or more
clearance from its surrounding walls.
2.Check if the unit is leveled.
If the unit wabbles, adjust the leveling
legs.
3.Adjust the leveling legs.
The 4 leveling legs should touch the
fl oor all together.
When the unit is not leveled
Lift up the unit a little bit and adjust the shortest.
Turn the leveling bolt counter clockwise as shown in the picture above
(The leveling leg gets longer.)
After adjusting the leveling bolt, tighten the
lock nut by turning it clockwise.
To Next Page
Loading...
