I r Temperature sensor problem.
High current detected.
_if_
2r High/Low voltage detected.
OZ
NF SilverCareTMcontrol problem
IC
Too many suds are detected
during the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will go back to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
To prevent it, cut down on detergents.
For any codes not listed above, call 1-800-726-7864 (1-800-SAMSUNG)
22 Troubleshooting
WF337A-02440A-06 EN.indd 22 2007-08-10 _;._t_._2:07:51
To Next Page
Loading...
