Samsung WF511AB series - Page 20

18 _ Removal and Reassembly
Part Figure Description
Disassembling and
Repairing the Water
Supply Valve
1. RemovetheTopAssy-Plate.
2. Disconnectthewatersupplyvalvewireconnector.
3. Removethe4screwsholdingthewatersupply
valve.
3. Removethehoseconnectedtothevalves.
(Usethepliertoremovethehose)
Disassembling and
Repairing the Water
Level Sensor
1. SeparatethewireconnectedtheSENSOR-
PRESSURE.
2. Adjusttheplasticclip(ofpressuresensor)between
twonoseofplier,thengripandpulltheplasticclip
withcaution(Usethelongnosepliertopushthe
hook).
3. RemovethehosefromtheSENSOR-PRESSURE.
Disassembling the
inside Detergent Box
• HoldtheClampoftheDetergentBoxand
disassembletheHose-Drawer-Tub.