❚
Connecting the Power Cord
<WAM5500, WAM3500 Only>
1 Connect the power cord of your speaker
as shown. It will connect at an angle.
2 Push the power cord into the notch at the
edge of the speaker bottom. This lets the
speaker rest flat when you stand it up.
<WAM1500 Only>
1 Connect the adaptor’s input power
cord to the adaptor.
2 Connect the adaptor’s output power
cord (with the round plug) to the DC
19V jack on the speaker.
3 Push the power cord into the notch at
the edge of the speaker bottom. This
lets the speaker rest flat when you
stand it up.
NOTE
9
Make sure to rest the AC/DC Adapter flat on a table or the floor. If you place the AC/DC Adapter so that
it is hanging with the AC cord input facing upwards, water or other foreign substances could enter the
Adapter and cause the Adapter to malfunction.
SPK ADD/Wi-Fi SETUP
SERVICE1 SERVICE2
POWER
ADD SPK/Wi-Fi SETUP
SERVICE1 SERVICE2
POWER
SPK ADD/Wi-Fi SETUP SERVICE
DC 19V
12
44
To Next Page
Loading...
