70
a. Select independent Gamma adjustment mode, including Red Gamma, Green
Gamma and Blue Gamma. (Only the MCTRL4K and MCTRL660 PRO support individual
Gamma adjustment for RGB.)
b. Set the grayscale bit value.
c. Drag the slider to adjust the Gamma value.
d. Under Recommended Gamma, select the Gamma mode, including Original, Mode
A and Mode B.
e. Under Picture Quality, select the picture quality mode, including Soft Mode and
Enhanced Mode.
f. Click Send.
Note:
Dragging the Gamma slider to set the Gamma value will adjust the Gamma curve and
Gamma table simultaneously.
l Move Up: Move the position of the selected value up in the Gamma table.
l Move Down: Move the position of the selected value down in the Gamma table.
l Save: Save the current Gamma values as a file.
l Load: Load a Gamma value configuration file from PC.
l Color temperature adjustment
− Rough adjustment: Select Rough Adjustment and drag the slider or enter a
number to set the color temperature.
− Precise adjustment: Select Precise Adjustment and click to enter the
Advanced Color Configuration page. On that page, click Import to import a color
temperature file, or click Add to set the color temperature information.
l Color space adjustment
− Disable: Do not enable color space adjustment.
− PAL/NTSC: Set the color system as PAL or NTSC.
Add configuration: Click to enter the Advanced Color Configuration page to
configure the color space parameters. Then, click Send and Save to HW.
To Next Page
Loading...
