Wireless network setup
160
2. Using a Network-Connected Machine
If below screen appears, press the (WPS) button from the control panel
within 2 minutes.
12
When the wireless network set up is completed, click Next.
13
After the installation is finished, click Close.
17
Using a network cable
Machines that do not support the network port will not be able to use this
feature (see "Rear view" on page 20).
Your machine is a network compatible machine. To enable your machine to
work with your network, you will need to perform some configuration
procedures.
• After completing the wireless network connection, you need to install a
machine driver to print from an application (see "Installing driver over
the network" on page 6).
• See your network administrator, or the person that set up your wireless
network, for information about your network configuration.
Items to prepare
• Access point
• Network-connected computer
• Software CD that was provided with your machine
• A machine installed with a wireless network interface
• Network cable
To Next Page
Loading...
