Marconi Sailing Club Ltd. MSCP83
Issue 2
Sanderson Teleporter Instructions & Code of Practice 21/03/2014
Page 12 of 17
BUCKET
a) The bucket is fitted to the Carriage. Firstly the forks may need to be removed. There is a slot in
the centre of the lower rail of the carriage that allows the lower lip of the fork to be pulled forwards
to release it from the rail. The first fork must be slid over to be adjacent to this slot and the bottom
pulled upwards to release. The carriage will then need to be tilted to release the top lip of the fork
from the carriage rail. It is necessary to have two persons to remove and replace the forks as
they are heavy and awkward to handle manually. Remove the second fork in the same way.
Drive into the centre of bucket and lift the boom so top lip of carriage hooks under top rail of
bucket. When it is hooked in tilt back the carriage until side rails cover the bucket rails. Then lift
lever to locate lock the pins into bucket holes to secure the bucket to the carriage.
b) The safe working load with bucket fitted is 2500kgs. The bucket must be calculated as part of the
load. NEVER OVERLOAD. A full bucket of sand or shingle will most likely overload the
Teleporter. Take care when raising the load. If overloaded the “Safe Load Indicator” will alarm. If
this occurs empty some of the load immediately. Never extend boom with full load.
To Next Page
Loading...