REAR CONNECTIVITY
Reference illustration 4.2 below.
1. Power Button—Press and hold for 2 seconds to power on or o the PRO-BLADE
STATION.
2. USB-C Power In Port—This is used to connect the PRO-BLADE STATION
to a power source. Use only the included power cable, WD Part Number:
M032-000042.
3. Thunderbolt 3 Host Port—This port can be used to connect the SanDisk
Professional
PRO-BLADE STATION to your host computer. Use only the included
data cable, WD Part Number: M032-000043.
4. Thunderbolt 3 Port—This port supports the following protocols: Thunderbolt 3,
DisplayPort 1.4, and SuperSpeed USB 10Gbps. This port provides up to 15-watts
of power to connected devices and can be used to daisy chain up to six
Thunderbolt 3 devices with a Thunderbolt 3 cable.
5. Kensington
®
Security Slot
—For device security, the device is equipped with
a security slot that supports a standard Kensington security cable. Visit
http://www.kensington.com/ for more information..
SIDE ANCHORS
Reference illustration 4.3 below.
1. Aluminum Enclosure
2. Anchor Points for Custom Mounting & Accessories—These bolts may be removed
to access the PRO-BLADE STATION's anchor points. These anchor points are
designed to be used for custom mounting, such as attaching your SanDisk
Professional
PRO-BLADE STATION to a DIT cart inside a rack, a "cheese plate",
adding a handle, or even an SSD holder.
NOTE:
Existing screws are not designed for attaching accessories or anchoring. Anchor
screws not included. Anchor points will accept a ¼”-20 screw. The screw length will vary
based on the type of mount.
PRO-BLADE STATION
SanDisk Professional
User Manual
10
To Next Page
Loading...
