Navigating the Software Menus ` 23
Example for Moving between Menus, Settings, and
Parameters
The following example shows how to use the player controls to navigate between menus,
settings, and a parameter under the Audio top level menu.
1. Press the Play/Stop button for two seconds. The SanDisk Welcome message will
appear onscreen for a moment then disappear. See The Basic Controls section
on page 4 to find the Play/Stop button.
WARNING: If the onscreen message says “Key Hold” and then shuts off, you
need to locate the Hold button on the side of your player. Slide that button
towards the Play/Stop button to unlock your device. Then repeat Step 1 above.
See The Basic Controls section on page 4 if you cannot find the Hold button.
2. Press down the Select button for two seconds. One of the top level menus shown in
Figure 6 above will appear.
3. Use the Left and Right buttons to navigate to the Audio menu as shown in Figure 7.
4. Press the Select button briefly to access the submenus under the Audio menu.
5. Press the Left and Right buttons to access the Speed submenu shown in Figure 8.
Figure 8: The Speed Submenu
Figure 7: The Audio Top Level Menu
To Next Page
Loading...
