BRUSH
VACUUM
Continuous flow
ACCESSORY
Selector:
External accessory /
Maintenance /
Deep Cleaning
Control panel and handle
Preparation for Work as a self-contained machine for carpet
1. Fill in the lower tank (solution tank) with cold or warm water, through the filling hole, adding a 5%
of not-foaming detergent (1/2 liter each 10 liters). If the machine is equipped with the optional
SMARTKIT, it is possible to put in the tank just clean water and keep separate the chemical
bottle. See the specific manual for more details.
Attention: wool carpet must be washed with cold water only!
2. Insert the plug of the cable into a wall socket (see Safety Regulations).
3. Check if the vacuum head is touching carpet. If it is raised from carpet, rotate forward the LEFT
handle of the machine. In this way the machine will move down with the vacuum shoe touching
the floor. This operation will require less effort if in the meantime you press down on the RIGHT
handle.
4. Set to position "I" the switches of the vacuum motor, the pump and the rotating brush.
Set the spray selector to maintenance cleaning ( ) or deep cleaning position ( ) .
Pump activated
from the RIGHT
handle
I I
I I
I
O O
To Next Page
Loading...
