2
2 - 32
W-2WAY ECO-i SYSTEM
Outdoor Unit Repair Procedures
10. Compressor
Installation
(1) Remove the 2 brazed tube caps (2 pieces) from the compressor.
(2) Remove hexagonal caps from the compressor.
* When removing the hexagonal caps, hold the fixing nut at the main unit side so as not to loose it with a
wrench or spanner. And then, loosen and remove the hexagonal cap.
(3) Remove the oil equalizer tube connector parts along with the O-ring from the removed compressor and
mount them on the replaced new compressor.
(4) Install the crankcase heater onto the new compressor.
(5) Temporary mount 2 cushion rubbers with bolts at the position as shown in the figure 27.
Set up the leg of the the new compressor onto the 2 cushion rubbers.
Fig. 26
Front view
Cushion rubbers
Bolts
(Temporary mounting: 2 locations
at back side, each 1 piece)
To Next Page
Loading...
