Sanyo Big PACi 18 Series - Page 135

1
1-130
Min. 300 or more
Min. 1000 or more
Installation with intakes facing
intakes or outlets facing outlets
Min. 200 or more
Min. 250* or
more
Min. 250* or
more
Not less than 150 or more
Min. 500 or more
Min. 150 or more
The front and both sides must remain open.
Installation in front-rear rows
Installation in lateral rows
(2) Multiple-unit installation
The top and both sides must remain open.
If there are obstacles to the front and rear of the outdoor unit,
the obstacle at either the front or rear must be no taller than the
height of the outdoor unit.
(1) Single-unit installation
If the air discharge chamber is used, the space shown below must be secured around the outdoor unit.
If the unit is used without the required space, a protective device may activate, preventing the unit from operating.
Required space around outdoor unit
CAUTION
CAUTION
CAUTION
● The amount of space required for
removing the screws on the rear of
the unit.
Unit: mm
Unit: mm
Unit: mm
If in case the sufficient space for
maintenance is ensured on the
rear of the outdoor unit, installation
is possible with the space of both
sides of not less than 150mm
where marked with * mark.
The front and top must remain open.
The obstacles must be no taller than the height of the outdoor unit.
NOTE
Reference diagram for air-discharge chamber (fi eld supply)
The models of SPW-C706 / 906VH8 with STK-UFV160E
SM830161Book.indb130SM830161Book.indb130 2008/06/039:08:132008/06/039:08:13