Sanyo Big PACi 18 Series - Page 138

1
1-133
1
Reference diagram for snow-proof duct - 1
Space requirements for setting - (1)
The models of SPW-C706 / 906VH8 with STK-BDV160E
Outdoor unit
MN
SPW-C706 / 906VH8
500 300
Outdoor unit
SPW-C706 / 906VH8
HI J
500 250* 1000
Min. I
or more
Min. M
or more
Min. L
or more
Min. I
or more
Min. H or more
Min. J or more
Min. N or more
Min. G or more
(1) Single-unit installation
(2) Multiple-unit installation (2 or more units)
Top is open:
Top is blocked by an obstacle:
(Both sides are open)
[Obstacle to the front of unit]
Outdoor unit
SPW-C706 / 906VH8
A B D ECFG
150 150
Outdoor unit
K
L
SPW-C706 / 906VH8
500 150
200250* 250* 150 200
or more
Min. B
Min. C
or more
Min. E
or more
Min. E
or more
Min. E
or more
Min. F
or more
Min. A or more
Min. D or more
Min. K or more
[Obstacle to the rear of unit]
(1) Single-unit installation
(3) Multiple-unit installation (2 or more units)
Top is open:
Top is blocked by an obstacle:
(Both sides are open)
(2) Obstacles on both sides
Notes: 1. In cases 2 and 3 the height of the obstacle
must be no taller than the height of the outdoor
unit.
2. The amount of space required for removing the
screw on the rear of the unit.
If in case the sufficient space for maintenance is
ensured on the rear of the outdoor unit,
installation is possible with the space of both
sides of not less than 150mm where marked
with * mark.
Note:
The amount of space required for removing
the screw on the rear of the unit.
If in case the sufficient space for
maintenance is ensured on the rear of the
outdoor unit, installation is possible with the
space of both sides of not less than 150mm
where marked with * mark.
Unit: mm
SM830161Book.indb133SM830161Book.indb133 2008/06/039:08:142008/06/039:08:14