EasyManua.ls Logo

Sanyo Big PACi 18 Series - 5-2. Contents of LED Display on the Outdoor Unit Control PCB

Sanyo Big PACi 18 Series
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-4
5
5-2. Contents of LED Display on the Outdoor Unit Control PCB
Power ON sequence
1. No communication from indoor units in system
2. Communication received from 1 or more indoor units in system
3. Regular communication OK (Capacity and unit quantity match)
If it is not possible to
advance to 3, repeats 1 2.
At 3, changes to normal
control.
P03
Normal operation
Pre-trip (insufficient gas)
Pre-trip (P20)
Pre-trip (other)
Automatic address setting in progress
Automatic address setting alarm (E15)
Automatic address setting alarm (E20)
Automatic address setting alarm (Other than E15 and E20)
Note:
This table shows examples of alarms.
Other type of alarms may also be displayed.
(0.25/0.75)
(0.75/0.25)
EEPROM error (F31)
Blinking alternately
Blinking simultaneously
Blinking simultaneously
Blinking simultaneously
Alarm
LED 1 blinks M times, and then LED 2 blinks N times.
The cycle then repeats.
M = 2: P alarm
6: L alarm
N = Alarm No.
* Refer to
Examples of alarm display below.
3: H alarm 4: E alarm 5: F alarm
Alternate blinking during alarms
Insufficient gas indicator
(0.25/0.75)
(0.75/0.25)
(0.25/0.75)
(0.75/0.25)
Refrigerant recovery mode
Automatic address setting
Displayed during automatic
address setting 1 and initial
communication. After these are
completed, alarm F31 is displayed.
P03
P04
P05
P31
H01
H02
H03
E04
F07
L13
(
"
)
(
"
)
(
"
)
(
"
)
(Blinks 3 times)
(
"
)
(
"
)
(Blinks 4 times)
(Blinks 5 times)
(Blinks 6 times)
(Blinks 3 times)
P02
( Blinks 2 times )
(Blinks 2 times)
(Blinks 4 times)
(Blinks 5 times)
(Blinks 31 times)
(Blinks 1 times)
(Blinks 2 times)
(Blinks 3 times)
(Blinks 4 times)
(Blinks 7 times)
(Blinks 13 times)
Alarm / Display
LED 1 Alternately LED 2
ON
:
:
:
LED 1 LED 2 Remarks
OFF
Examples of alarm display (other than E15, E16, and E20)
Blinking (0.25/0.75) indicates that the lamp illuminates for 0.25 seconds, and then is OFF for 0.75 seconds.
Unless otherwise indicated, the blinking is (0.5/0.5).
SM830161Book.indb4SM830161Book.indb4 2008/06/039:10:262008/06/039:10:26

Table of Contents

Related product manuals